Alphabet of lines Quiz | PDF - Free Printable

Let’s go step by step to identify each numbered line in the technical drawing based on standard engineering drawing conventions.

We’ll match each number (1 through 10) to the correct type of line from the list provided:

Line types available:
- Visible line
- Hidden line
- Section line
- Phantom line
- Short-break line
- Dimension line
- Center line
- Leader line
- Reference line
- Extension line
- Cutting-plane line
- Stitch line

---

Now, let’s analyze each numbered line one by one:

Line 1: This is a long dashed line with two short dashes at each end — it goes across the top and points to a feature. In engineering drawings, this is typically a cutting-plane line, which shows where a section view is taken. The arrows indicate direction of sight.

→ Cutting-plane line

Line 2: This is a thin solid line extending from the object to show where a dimension starts or ends. It doesn’t have arrowheads itself but connects to dimension lines. That’s an extension line.

→ Extension line

Line 3: This is a thin solid line with arrowheads on both ends, showing the actual measurement (like “7.5”). That’s a dimension line.

→ Dimension line

Line 4: This is a curved thin solid line with an arrowhead pointing to a specific point on the drawing, often used to call out a note or detail. That’s a leader line.

→ Leader line

Line 5: This is a long dash followed by two short dashes, repeating — that’s the standard for a phantom line, used to show alternate positions or repeated details.

→ Phantom line

Line 6: This is a circle made of alternating long and short dashes — that’s a center line, used to mark centers of circles or symmetry.

→ Center line

Line 7: This is a thick continuous line outlining the visible edges of the object — that’s a visible line.

→ Visible line

Line 8: This is a series of short evenly spaced parallel lines inside a cut area — that’s section lining (also called cross-hatching), indicating material that has been cut.

→ Section line

Line 9: This is a wavy or zigzag thin line breaking off part of the view — that’s a short-break line, used to shorten long objects or break away sections.

→ Short-break line

Line 10: This is a thin solid line running horizontally under the main view, aligned with features above — likely a reference line, used to align views or indicate datum planes.

→ Reference line

Wait — let’s double-check Line 10. Looking again: it’s a straight horizontal line below the main view, possibly connecting to another view or serving as a baseline. In some contexts, this could also be considered an extension line, but since we already used “extension line” for #2, and #10 seems more like a reference plane or alignment guide, “reference line” fits better.

Also, check if any are missing: we haven’t used “hidden line” or “stitch line”. But looking at the diagram, there are no hidden features shown with dashed lines (except phantom and center), and no stitching indicated. So those aren’t needed here.

Let’s verify all 10:

1 → Cutting-plane line
2 → Extension line
3 → Dimension line
4 → Leader line
5 → Phantom line
6 → Center line
7 → Visible line
8 → Section line
9 → Short-break line
10 → Reference line

All match standard definitions.

Final Answer:
1. Cutting-plane line
2. Extension line
3. Dimension line
4. Leader line
5. Phantom line
6. Center line
7. Visible line
8. Section line
9. Short-break line
10. Reference line