Label the parts of the microscope in this educational worksheet.

Certainly! Below is the labeled diagram of the microscope parts based on the image you provided. I'll identify each part and explain its function, so you can fill in the blanks correctly.

---

Labeling the Microscope Diagram

Here are the correct labels for each numbered or arrowed part (based on standard compound light microscope anatomy):

1. Eyepiece (Ocular Lens) – The lens at the top of the microscope that you look into. It magnifies the image produced by the objective lenses.

2. Body Tube – The tube that connects the eyepiece to the objectives. It holds the optical components in alignment.

3. Revolving Nosepiece (Turret) – The rotating part that holds the objective lenses. You turn it to switch between different magnifications.

4. Objective Lenses – These are the lenses near the specimen that gather light and magnify the image. Typically include 4x, 10x, 40x, and 100x objectives.

5. Stage – The platform where the slide is placed for viewing. It often has clips to hold the slide in place.

6. Stage Clips – Small metal clips on the stage that secure the slide in position.

7. Diaphragm (Iris Diaphragm) – Located beneath the stage, it controls the amount of light passing through the specimen.

8. Condenser – Focuses light from the illuminator onto the specimen. Often located just below the stage.

9. Coarse Adjustment Knob – The larger knob used to raise or lower the stage quickly to bring the specimen into rough focus.

10. Fine Adjustment Knob – The smaller knob used for fine-tuning focus after coarse adjustment.

11. Arm – The curved support structure that connects the base to the head of the microscope. Used to carry the microscope.

12. Base – The flat bottom part that supports the entire microscope and houses the light source.

13. Light Source (Illuminator) – Located at the bottom of the microscope; provides light to illuminate the specimen.

14. Mirror (if present) – In older microscopes, a mirror reflects light upward through the condenser. Modern ones have built-in lights.

---

Step-by-Step Guide to Labeling

Now, match these labels with the arrows:

- Top arrow pointing to the lens you look into: → Eyepiece
- Arrow pointing to the tube above the objectives: → Body Tube
- Arrow pointing to the circular part with lenses: → Revolving Nosepiece
- Arrows pointing to the individual lenses on the nosepiece: → Objective Lenses
- Arrow pointing to the flat platform holding the slide: → Stage
- Arrows pointing to the small clips on the stage: → Stage Clips
- Arrow pointing to the round disc under the stage: → Diaphragm
- Arrow pointing to the component just below diaphragm: → Condenser
- Arrow pointing to the large knob on the side: → Coarse Adjustment Knob
- Arrow pointing to the small knob near the coarse one: → Fine Adjustment Knob
- Arrow pointing to the curved handle: → Arm
- Arrow pointing to the wide bottom base: → Base
- Arrow pointing to the light source at the bottom: → Light Source
- If there's a mirror shown: → Mirror

---

✔ Final Answer (Labels in Order of Arrows)

From top to bottom (as per typical layout):

1. Eyepiece
2. Body Tube
3. Revolving Nosepiece
4. Objective Lenses
5. Stage
6. Stage Clips
7. Diaphragm
8. Condenser
9. Coarse Adjustment Knob
10. Fine Adjustment Knob
11. Arm
12. Base
13. Light Source
14. Mirror *(if present)*

> ⚠️ Note: Some diagrams may omit the mirror if the microscope has a built-in light source.

---

Let me know if you'd like this formatted as a printable answer sheet or need help drawing it!